No Brand CKG5060S Bedienungsanleitung PDF herunterladen (Seite 10)

10

Due to the large range of wall types

and different fixings required for each

type, the fixings are not supplied, so

the appropriate fixings should be

obtained from a hardware store.

NOTE! If the space between

kitchen units is wider than the

cooker, you will need to alter the

measurements shown in the

illustration if the cooker is to be

centered.

If you alter the measurements,

remember to align the cooker correctly

when pushing it into place, so that the

non-tip device enters the hole on the

cooker rear.

Instructions for locating and

installation of safety locating

bolt.

When installed, the safety locating

bolt will prevent the cooker from being

moved forward causing the anti tilt

bracket to become disengaged from

the rear of the cooker.

In order to install the safety locating

bolt you will have to drill a hole in the

floor.

With the cooker in position it will

permanently occupy and the anti tilt

bracket fully engaged in the slot in the

back panel of the cooker, remove the

bottom drawer from the cooker,

reach inside and locate the safety

locating bolt located at the half of

distance between the 2 front feet of

the cooker and screw the safety

locating bolt until it gently touches

the floor.

After you have marked the hole

position move the cooker in order to

drill a 5mm diameter hole 20 mm

deep.

Move the cooker back into its

permanent position with anti-tilt

bracket engaged and screw the

safety locating bolt into the hole in

the floor.

Try to pull the cooker forward to

confirm that the screw is sufficiently

engaged in the floor hole.

Confirm that the anti tilt bracket is

sufficiently engaged into the rear of

the cooker by putting some weight

on the open oven door. (not so much

that it causes damage…)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare